Welcome

   To SAVER BLINDS, your factory direct blinds online superstore. From Perth to Melbourne, We are the 1# store for blinds.

Helpful Tools

HOW TO MEASURE:

  • Make sure you use a steel tape measure
  • Always take your measurements in millimeters (mm)
  • Always take the exact measurement, do not round them up
  • Always take the Width first, then the Drop

 

 

Measuring the Width: Get the first inner measurement at the top of the window, wall to wall of window frame (inner edge). Then get the second measurement at the middle of the window, wall to wall of window frame (inner edge) and third measurement at the bottom of the window, wall to wall of window frame (inner edge). This is to check if your window is square. Write down the shortest measurement as the width for this window.

Measuring the Drop: Get the first measurement at the right side of the window frame, top to bottom, inside of the frame. Then get the second inner measurement at the left side of the window, top to bottom, inside of the frame. Write down the shorter measurement as the drop for this window.

 

 

Measuring the Width: Get the first measurement at the top of the window frame, edge to edge (outer edge of the architrave). Then get the second measurement at the middle of the window, edge to edge (outer edge of the architrave) and then third at the bottom of the window frame, edge to edge (outer edge of the architrave). This is to check if your window is square. Write down the shortest measurement as the width for this window.

Measuring the Drop: Get the first measurement at the right side of the window frame, edge to edge (outer edge of the architrave). Then get the second measurement at the left side of the window frame, edge to edge (outer edge of the architrave). Write down the shorter measurement as the drop for this window.

 

These are your hard measurements (meaning no deduction or allowance has been made). Do not make any deductions or allowances, the factory will make the correct deduction for you.

 Check your measurements three times to avoid any errors before placing the order.

For specific product measuring details, please do not hesitate to contact or email us at: tech@saversblinds.com.au or 1300 739 957.

 

 

Username can't be empty.

Show Password can't be empty.

Forgot your password?

Username is empty. username already exists.

Email is empty! Email already exists. Please enter valid email.

Show Password is empty!

Lost your password? Please enter your email address.

 

Email is empty! This email is not registered with the system. Please enter valid email.

Back to log-in

Close